Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2070)

Ping-Polling Commands
Software Reference for x310 Series Switches
79.12 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
ping-poll
This command enters the ping-poll configuration mode. If a ping-poll exists with the
specified number, then this command enters its configuration mode. If no-ping poll exists
with the specified number, then this command creates a new ping poll with this ID
number.
To configure a ping-poll, create a ping poll using this command, and use the ip (ping-
polling) command to specify the device you want the polling instance to poll. It is not
necessary to specify any further commands unless you want to change a command’s
default.
The no variant of this command deletes the specified ping poll.
Syntax ping-poll <1-100>
no ping-poll <1-100>
Mode Global Configuration
Examples To create ping-poll instance 3 and enter ping-poll configuration mode, use the
commands:
To delete ping-poll instance 3, use the commands:
Related Commands active (ping-polling)
clear ping-poll
debug ping-poll
description (ping-polling)
ip (ping-polling)
length (ping-poll data)
show ping-poll
source-ip
Parameter Description
<1-100> A unique ping poll ID number.
awplus# configure terminal
awplus(config)# ping-poll 3
awplus(config-ping-poll)#
awplus# configure terminal
awplus(config)# no ping-poll 3