Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1808)

SNMP Commands
Software Reference for x310 Series Switches
68.26 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
snmp-server startup-trap-delay
Use this command to set the time in seconds after following completion of the switch
startup sequence before the switch sends any SNMP traps (or SNMP notifications).
Use the no variant of this command to restore the default startup delay of 30 seconds.
Syntax snmp-server startup-trap-delay <delay-time>
no snmp-server startup-trap-delay
Default The SNMP server trap delay time is 30 seconds. The no variant restores the default.
Mode Global Configuration
Example To delay the switch sending SNMP traps until 60 seconds after switch startup, use the
following commands:
To restore the sending of SNMP traps to the default of 30 seconds after switch startup, use
the following commands:
Validation
Commands
show snmp-server
Parameter Description
<delay-time> Specify an SNMP trap delay time in seconds in the range of
30 to 600 seconds.
awplus# configure terminal
awplus(config)# snmp-server startup-trap-delay 60
awplus# configure terminal
awplus(config)# no snmp-server startup-trap-delay