Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1085)

802.1X Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 41.19
show dot1x interface
This command shows the status of 802.1X port-based authentication on the specified
interface, which may be a static channel (or static aggregator) or a dynamic (or LACP)
channel group or a switch port.
Use the optional diagnostics parameter to show authentication diagnostics for the
specified interfaces. Use the optional sessionstatistics parameter to show authentication
session statistics for the specified interfaces. Use the optional statistics parameter to show
authentication diagnostics for the specified interfaces. Use the optional supplicant
parameter to show the supplicant state for the specified interfaces.
For information on output options, see “Controlling “show” Command Output” on
page 1.37 .
Syntax show dot1x interface <interface-list>
[diagnostics|sessionstatistics|statistics|supplicant [brief]]
Mode Privileged Exec
Examples See the sample output below showing 802.1X authentication status for port1.0.6:
Parameter Description
The interfaces or ports to configure. An interface-list can be:
■ an interface (e.g. vlan2), a switch port (e.g.
port1.0.6
), a static channel group (e.g. sa2) or a
dynamic (LACP) channel group (e.g. po2)
■
a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by
a hyphen;
e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2, or
po1-2
■
a comma-separated list of the above;
e.g. port1.0.1,port1.0.3-1.0.5. Do not mix
interface types in a list
The specified interfaces must exist.
diagnostics Diagnostics.
sessionstatistics Session Statistics.
statistics Statistics.
supplicant Supplicant.
brief Brief summary of supplicant state.
awplus# show dot1x interface port1.0.6