Show counter ntp – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1684
NTP Commands
Software Reference for x310 Series Switches
62.14
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
show counter ntp
This command displays packet counters for NTP.
Syntax
show counter ntp
Mode
User Exec and Privileged Exec
Output
Figure 62-1: Example output from the show counter ntp command
Example
To display counters for NTP, use the command:
NTP counters
Pkts Sent ......... 0
Pkts Received ......... 70958
Pkts Processed ......... 0
Pkts current version ......... 0
Pkts old version ......... 0
Pkts unknown version ......... 0
Pkts access denied ......... 70958
Pkts bad length ......... 0
Pkts bad auth ......... 0
Pkts rate exceed ......... 0
Table 62-1: Parameters in the output from the show counter ntp command
Parameter
Description
Pkts Sent
Total number of NTP client and server packets sent by your
device.
Pkts Received
Total number of NTP client and server packets received by your
device.
Pkts Processed
The number of packets processed by NTP. NTP processes a
packet once it has determined that the packet is valid by
checking factors such as the packet’s authentication, format,
access rights and version.
Pkts current
version
The number of version 4 NTP packets received.
Pkts old
version
The number of NTP packets received that are from an older
version, down to version 1, of NTP. NTP is compatible with these
versions and processes these packets.
Pkts unknown
version
The number of NTP packets received that are an earlier version
than version 1, or a higher version than version 4. NTP cannot
process these packets.
Pkts access
denied
The number of NTP packets received that do not match any
access list statements in the NTP access-groups. NTP drops these
packets.
Pkts bad
length
The number of NTP packets received that do not conform to the
standard packet length. NTP drops these packets.
Pkts bad auth
The number of NTP packets received that failed authentication.
NTP drops these packets. Packets can only fail authentication if
NTP authentication is enabled with the
command.
Pkts rate
exceed
The number of packets dropped because the packet rate
exceeded its limits.
awplus#
show counter ntp