Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1592)

AMF Commands
Software Reference for x310 Series Switches
60.4 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
atmf backup bandwidth
This command sets the maximum bandwidth in kilobytes per second (kBps) available to
the AMF backup process. Basically this command enables you to restrict the bandwidth
that is utilized for downloading file contents during a backup.
Use the no variant of this command to reset (to its default value of zero) the maximum
bandwidth in kilobytes per second (kBps) available when initiating an AMF backup. A
value of zero tells the backup process to transfer files using unlimited bandwidth.
Syntax atmf backup bandwidth <0-1000>
no atmf backup bandwidth
Default The default value is zero, allowing unlimited bandwidth when executing an AMF backup.
Mode Global Configuration
Examples To set an atmf backup bandwidth of 750 kBps, use the commands:
To set the atmf backup bandwidth to the default value for unlimited bandwidth, use the
commands:
Related Commands show atmf backup
Note This command will only run on an AMF master. An error message will be
generated if run on a node if the command is attempted on node that is not a
master.
Also note that setting the bandwidth value to zero will allow the transmission of
as much bandwith as is available, which can excede the maximum configurable
speed of 100 kBps. So effectively, zero means unlimited.
Parameter Description
<0-1000> Sets the bandwidth in kilobytes per second (kBps)
node2# configure terminal
node2(config)# atmf backup bandwidth 750
node2# configure terminal
node2(config)# no atmf backup bandwidth