Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1146)

Authentication Commands
Software Reference for x310 Series Switches
43.20 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Default No supplicant MAC address for port authentication exists by default until first created with
the auth supplicant-mac command. The defaults for parameters applied are as shown in
the table.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a switch
port.
Examples To add the supplicant MAC address 0009.41A4.5943 to force authorized port control
for interface port1.0.2, use the following commands:
To delete the supplicant MAC address 0009.41A4.5943 for interface port1.0.2, use
the following commands:
To reset reauthentication to disable for the supplicant MAC address 0009.41A4.5943,
for interface port1.0.2 use the following commands:
Validation
Commands
show dot1x
show dot1x interface
show running-config
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth supplicant-mac 0009.41A4.5943 port-
control force-authorized
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth supplicant-mac 0009.41A4.5943
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth supplicant-mac 0009.41A4.5943
reauthentication