Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 278)

Logging Commands
Software Reference for x310 Series Switches
10.6 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
default log monitor
This command restores the default settings for log messages sent to the terminal when a
terminal monitor command is used.
Syntax default log monitor
Default All messages are sent to the terminal when a terminal monitor command is used.
Mode Global Configuration
Example To restore the log monitor to its default settings use the following commands:
Related Commands log monitor (filter)
show log config
default log permanent
This command restores the default settings for the permanent log stored in NVS. By
default, the size of the permanent log is 50 kB and it accepts messages with the severity
level of warnings and above.
Syntax default log permanent
Default The permanent log is enabled by default.
Mode Global Configuration
Example To restore the permanent log to its default settings use the following commands:
Related Commands log permanent
log permanent size
show log config
awplus# configure terminal
awplus(config)# default log monitor
awplus# configure terminal
awplus(config)# default log permanent