Log permanent – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 302
Logging Commands
Software Reference for x310 Series Switches
10.30
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
log permanent
This command configures the device to send log messages to non-volatile storage (NVS)
on the device. Log messages sent to NVS are retained on the device over a restart, that is
they are permanent. Once the permanent log reaches its configured maximum allowable
size old messages will be deleted to make way for new ones.
The no variant of this command configures the device not to send any messages to the
permanent log. Log messages will not be retained over a restart.
Syntax
log permanent
no log permanent
Mode
Global Configuration
Examples
To enable permanent logging use the following commands:
To disable permanent logging use the following commands:
Validation
Commands
Related Commands
default log permanent
log permanent (filter)
log permanent size
show log permanent
awplus#
configure terminal
awplus(config)#
log permanent
awplus#
configure terminal
awplus(config)#
no log permanent