beautypg.com

Power-inline usage-threshold, Power, Inline usage-threshold – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 610: Comma, Power-inline usage-threshold <1-99

background image

Power over Ethernet Commands

Software Reference for x310 Series Switches

23.12

AlliedWare Plus

TM

Operating System - Version 5.4.4C

C613-50046-01 REV A

power-inline usage-threshold

This command sets the level at which the Power Sourcing Equipment (PSE) will issue a
message that the power supplied to all Powered Devices (PDs) has reached a critical level
of the nominal power rating for the PSE. The level is set as a percentage of total available
power.

The no variant of this command resets the notification usage-threshold to the default
(80% of the nominal power rating of the PSE).

Syntax

power-inline usage-threshold <1-99>

no power-inline usage-threshold

Default

The default power usage threshold is 80% of the nominal power rating of the PSE.

Mode

Global Configuration

Usage

Use the

snmp-server enable trap command on page 68.16

to configure SNMP

notification. An SNMP notification is sent when the usage-threshold, as configured in the
example, is exceeded.

Examples

To generate SNMP notifications when power supplied exceeds 70% of the nominal PSE
power, use the following commands:

To reset the notification threshold to the default (80% of the nominal PSE power rating),
use the following commands:

Validation

Commands

show power-inline interface
show running-config power-inline

Related Commands

snmp-server enable trap

Parameter

Description

<1-99>

The usage-threshold percentage configured with this
command.

awplus#

configure terminal

awplus(config)#

snmp-server enable trap power-inline

awplus(config)#

power-inline usage-threshold 70

awplus#

configure terminal

awplus(config)#

no power-inline usage-threshold