Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 804)

MLD and MLD Snooping Introduction and Commands
Software Reference for x310 Series Switches
32.20 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
ipv6 mld query-max-response-time
Use this command to configure the maximum response time advertised in MLD queries.
Use the no variant of with this command to restore the default.
Syntax ipv6 mld query-max-response-time
no ipv6 mld query-max-response-time
Default 10 seconds
Mode Interface Configuration for a specified VLAN interface or a range of VLAN interfaces.
Usage This command applies to interfaces configured for MLD Layer-3 multicast protocols.
Example The following example configures a maximum response time of 8 seconds:
Parameter Description
<seconds> Maximum response time (in seconds) advertised in MLD queries.
Valid values are from 1 to 240 seconds.
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# interface vlan2
awplus(config-if)# ipv6 enable
awplus(config-if)# ipv6 mld query-max-response-time 8