Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 405)

Switching Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 15.43
show port-security interface
Use this command to show the current port-security configuration and the switch port
status.
Syntax show port-security interface <port>
Mode Privileged Exec
Example To see the port-security status on port1.0.1, use the following command:
Output Figure 15-11: Example output from the show port-security interface command
Parameter Description
The port to display information about. The port may be a switch
port (e.g. port1.0.4), a static channel group (e.g. sa3), or a
dynamic (LACP) channel group (e.g. po4).
awplus# show port-security interface port1.0.1
Port Security configuration
Security Enabled : YES
Port Status : ENABLED
Violation Mode : TRAP
Aging : OFF
Maximum MAC Addresses : 3
Total MAC ddresses : 1
Lock Status : UNLOCKED
Security Violation Count : 0
Last Violation Source Address : None