Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1140)

Authentication Commands
Software Reference for x310 Series Switches
43.14 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
auth reauthentication
This command enables re-authentication on the interface specified in the Interface mode,
which may be a static channel group (or static aggregator) or a dynamic (or LACP) channel
group or a switch port.
Use the no variant of this command to disables reauthentication on the interface.
Syntax auth reauthentication
no auth reauthentication
Default Reauthentication of port authentication is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a switch
port.
Examples To enable reauthentication on interface port1.0.2, use the following commands:
Validation
Commands
show dot1x
show dot1x interface
show running-config
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth reauthentication