Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 789)

MLD and MLD Snooping Introduction and Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 32.5
Enabling MLD Snooping globally and on an interface
To globally enable and show MLD Snooping on the switch, enter the commands:
Note that entering show ipv6 mld interface without an optional interface
parameter displays MLD information for all configured interfaces globally on the switch.
To enable and show MLD Snooping on VLAN interface vlan2, enter the commands:
Note that entering show ipv6 mld interface vlan2 with the optional interface
parameter displays MLD information for that specified configured interface on the switch.
Configuring a Multicast Router statically on an interface
To configure and show a static connection to a Multicast Router for VLAN interface
vlan2
, enter the commands:
Note the VLAN interface to the Multicast Router must be administratively up and the line
protocol must be up to configure a static connection to a Multicast Router on the VLAN.
awplus# configure terminal
awplus(config)# ipv6 mld snooping
awplus(config)# exit
awplus# show ipv6 mld interface
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 mld snooping
awplus(config-if)# exit
awplus(config)# exit
awplus# show ipv6 mld interface vlan2
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 mld snooping mrouter interface
port1.0.2
awplus(config-if)# exit
awplus(config)# exit
awplus# show ipv6 mld interface vlan2