Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 461)

VLAN Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 17.33
vlan classifier activate
Use this command in Interface Configuration mode to associate a VLAN classifier group
with the switch port.
Use the no variant of this command to remove the VLAN classifier group from the switch
port.
Syntax vlan classifier activate <vlan-class-group-id>
no vlan classifier activate <vlan-class-group-id>
Mode Interface Configuration mode for a switch port.
Usage See the Protocol based VLAN configuration example section in Chapter 16, VLAN
Introduction for a configuration example and network topology using this command.
Example To remove VLAN classifier group 3 from switch port1.0.3, enter the following
commands:
Related Commands show vlan classifier rule
vlan classifier group
vlan classifier rule ipv4
vlan classifier rule proto
Parameter Description
<vlan-class-group-id> Specify a VLAN classifier group identifier in the range
<1-16>.
awplus# configure terminal
awplus(config)# interface port1.0.3
awplus(config-if)# no vlan classifier activate 3