Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2170)

Stacking Commands
Software Reference for x310 Series Switches
83.30 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
switchport resiliencylink
This command configures the switch port to be a member of the stack resiliency link
VLAN. Note that this switchport will only be used for stack resiliency-link traffic and will
not perform any other function, or carry any other traffic.
The no variant of this command removes the switchport from the resiliency link VLAN.
Syntax switchport resiliencylink
no switchport resiliencylink
Mode Global Configuration to create then Interface Configuration to assign the resiliency link.
Examples To set the resiliency link to be VLAN 4093:
First, use the stack resiliencylink command to create the resiliency vlan4093
Next, use the switchport resiliencylink command to assign the resiliencylink vlan to the
port, in this case port1.0.1.
Related Commands stack resiliencylink
show stack resiliencylink
undebug stack
This command applies the functionality of the no debug stack command on page 83.3 .
awplus# configure terminal
awplus(config)# stack resiliencylink vlan4093
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# switchport resiliencylink