Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 337)

Interface Testing Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 13.3
service test
This command puts the device into the interface testing state, ready to begin testing. After
entering this command, enter Interface Configuration mode for the desired interfaces and
enter the command
test interface .
Do not test interfaces on a device that is part of a live network—disconnect the device
first.
Use the no variant of this command to stop the test service.
Syntax service test
no service test
Mode Global Configuration
Example To put the device into a test state, use the command:
Related Commands test interface
awplus(config)# service test