Show epsr config-check – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1540
EPSR Commands
Software Reference for x310 Series Switches
58.14
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
show epsr config-check
This command checks the configuration of a specified EPSR instance, or all EPSR instances.
If an instance is enabled, this command will check for the following errors or warnings:
■
The control VLAN has the wrong number of ports.
■
There are no data VLANs.
■
Some of the data VLANs are not assigned to the ring ports.
■
The failover time is less than 5 seconds, for a stacked device.
■
The instance is a master that shares a common segment with a higher priority
instance.
■
The instance is a master that shares a common segment with another master.
■
The instance is a master with its secondary port on a common segment.Syntax.
Syntax
show epsr {
Mode
User Exec and Privileged Exec
Example
To check the configuration of all EPSR instances and display the results, use the command::
Output
Related Commands
Parameter
Description
<instance>
Name of the EPSR instance to check on.
awplus#
show epsr config-check
Figure 58-4: Example output from the show epsr config-check command
EPSR Status Description
Instance
--------------------------------------------------------------------------------
red Warning Failover time is 2s but should be 5s because device.
is stacked
white OK.
blue Warning Primary port is not in data VLANs 29-99.
orange OK.
Don't forget to check that this node's configuration is consistant with all
other nodes in the ring.
--------------------------------------------------------------------------------