Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 885)

IPv4 Hardware Access Control List (ACL) Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 34.39
show interface access-group
Use this command to display the access groups attached to a port. If an access group is
specified, then the output only includes the ports that the specified access group is
attached to. If no access group is specified then this command displays all access groups
that are attached to the ports that are specified with .
Note that access group is the term given for an access-list when it is applied to an
interface.
Syntax show interface <port-list> access-group [<3000-3699>|<4000-4699>]
Mode User Exec and Privileged Exec
Example To show all access-lists attached to port1.0.1, use the command:
Output Figure 34-1: Example output from the show interface access-group command
Related Commands access-group
Note This command will function on your switch in stand-alone mode. but is not
supported when the device forms part of a VCStack.
Parameter Description
Specify the ports to display information. A port-list can be
either:
■
a switch port (e.g. port1.0.6) a static channel group (e.g.,
sa2) or a dynamic (LACP) channel group (e.g., po2)
■
a continuous range of ports separated by a hyphen,
e.g., port1.0.1-1.0.6 or port1.0.1-port1.0.6 or po1-po2
■ a comma-separated list of ports and port ranges,
e.g. port1.0.1,port1.0.3-1.0.6. Do not mix switch ports,
static channel groups, and LACP channel groups in the
same list.
access group Select the access group whose details you want to show.
<3000-3699> Specifies the Hardware IP access-list.
<4000-4699> Specifies the Hardware MAC access-list.
awplus# show interface port1.0.1 access-group
Interface port1.0.1
access-group 3000
access-group 3002
access-group 3001