Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 604)

Power over Ethernet Commands
Software Reference for x310 Series Switches
23.6 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
power-inline description
This command adds a description for a Powered Device (PD) connected to a PoE port.
The no variant of this command clears a previously entered description for a connected
PD, resetting the PD description to the default (null).
Syntax power-inline description <pd-description>
no power-inline description
Default No description for a connected PD is set by default.
Mode Interface Configuration
Usage Select a PoE port, a list of PoE ports, or a range of PoE ports with the preceding interface
(to configure) command. If you specify a range or list of ports they must all be PoE
capable ports.
Examples To add the description Desk Phone for a connected PD on port1.0.2, use the
following commands:
To clear the description as added above for the connected PD on port1.0.2, use the
following commands:
Validation
Commands
show power-inline interface
show running-config power-inline
Parameter Description
<pd-description> Description of the PD connected to the PoE capable port
(with a maximum 256 character string limit per PD
description).
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# power-inline description Desk Phone
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no power-inline description