Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1876)

SNMP MIBs
Software Reference for x310 Series Switches
69.64 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
deviceConfiguration { setup 3 Objects for managing device configuration.
runningConfig { deviceConfiguration
1 }
runCnfgSaveAs { runningConfig 1 } Set with a URL to save the currently running software
to the root of Flash or USB flash drive (e.g. 'flash:/
filename.rel' or 'usb:/filename.rel'). The URL must not
contain whitespace characters.
Only one set operation can be executed at a time
across all SNMP users and an operation may not be
started unless the current value of
runCnfgSaveAsStatus is 'idle'. Immediately upon
executing the set action, the system will attempt to
save the running configuration and the process will
continue on the device until it has completed or a
failure occurs.
When read, this object will return the URL of the last
firmware save operation that was attempted.
runCnfgSaveAsStatus { runningConfig 2 } Returns the status of any current operation to save the
running configuration. The following values may be
returned:
1. (idle) - there is no config file save operation in
progress
2. (success) - the last config file save operation
completed successfully
3. (failure) - the last config file save operation failed
4. (saving) - a config file save operation is currently in
progress
When a read of this object returns a value of 'success'
or 'failure', it will immediately be reset to 'idle' and a
new operation may be initiated if desired. A detailed
description of the last completed operation may be
determined by reading runCnfgLastSaveResult.
runCnfgLastSaveResult { runningConfig 3 } Gives an indication of the result of the last completed
SNMP operation to save the running configuration.
nextBootConfig { deviceConfiguration
2 }
Table 69-18: Objects defined in AT-SETUP-MIB
Object Identifier Description Object Identifier