Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1931)

LLDP Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 71.5
lldp faststart-count
Use this command to set the fast start count for LLDP-MED. The fast start count
determines how many fast start advertisements LLDP sends from a port when it starts
sending LLDP-MED advertisements from the port, for instance, when it detects a new
LLDP-MED capable device.
The no variant of this command resets the LLDPD-MED fast start count to the default (3).
Syntax lldp faststart-count <1-10>
no lldp faststart-count
Default The default fast start count is 3.
Mode Global Configuration
Examples To set the fast start count to 5, use the command:
To reset the fast start count to the default setting (3), use the command:
Related Commands show lldp
Parameter Description
<1-10> The number of fast start advertisements to send.
awplus# configure terminal
awplus(config)# lldp faststart-count 5
awplus# configure terminal
awplus(config)# no lldp faststart-count