Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 276)

Logging Commands
Software Reference for x310 Series Switches
10.4 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
default log buffered
This command restores the default settings for the buffered log stored in RAM. By default
the size of the buffered log is 50 kB and it accepts messages with the severity level of
“warnings” and above.
Syntax default log buffered
Default The buffered log is enabled by default.
Mode Global Configuration
Example To restore the buffered log to its default settings use the following commands:
Validation
Commands
show log config
Related Commands log buffered
log buffered size
default log console
This command restores the default settings for log messages sent to the terminal when a
log console command is issued. By default all messages are sent to the console when a
log console command is issued.
Syntax default log console
Mode Global Configuration
Example To restore the log console to its default settings use the following commands:
Validation
Commands
show log config
Related Commands log console
log console (filter)
awplus# configure terminal
awplus(config)# default log buffered
awplus# configure terminal
awplus(config)# default log console