Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1531)

EPSR Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 58.5
epsr enhancedrecovery enable
This command enables EPSR’s enhanced recovery mode. Enhanced recovery mode
enables a ring to apply additional recovery procedures when a ring with more than one
break, partially mends. For more information see,
“Managing Rings with Two Breaks” on
page 57.6 .
The no variant of this command disables the enhancedrecovery mode.
Syntax epsr enhancedrecovery enable
no epsr enhancedrecovery enable
Default Default is enhancedrecovery mode disabled.
Mode EPSR Configuration
Example To apply enhanced recovery on the EPSR instance called blue, use the command:
Related Commands show epsr
epsr mode master controlvlan primaryport
This command creates a master EPSR instance. It will not run on x310 Series switches,
because these switches are only able to function as transit nodes. To form an EPSR ring
using x310 Series switches you will need to use an alternative Allied Telesis switch, such as
an x610 Series switch, as the master node.
Parameter Description
Name of the EPSR instance.
awplus(config-epsr)# epsr blue enhancedrecovery enable