Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1016)

QoS Commands
Software Reference for x310 Series Switches
39.10 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
match eth-format protocol
This command sets the ethernet format and the protocol for a class-map to match on.
Select one Layer 2 format and one Layer 3 protocol when you issue this command.
Use the no variant of this command to remove the configured ethernet format and
protocol from a class-map.
Syntax match eth-format <layer-two-format> protocol <layer-three-protocol>
no match eth-format protocol
Parameter Description
<layer-two-formats>
802dot2-tagged 802.2 Tagged Packets (enter the parameter name).
802dot2-untagged 802.2 Untagged Packets (enter the parameter name).
ethii-tagged EthII Tagged Packets (enter the parameter name).
ethii-untagged EthII Untagged Packets (enter the parameter name).
netwareraw-
tagged Netware Raw Tagged Packets (enter the parameter
name).
netwareraw-
untagged Netware Raw Untagged Packets (enter the parameter
name).
snap-tagged SNAP Tagged Packets (enter the parameter name).
snap-untagged SNAP Untagged Packets (enter the parameter name).
<layer-three-protocols>
A Valid Protocol Number in hexidecimal.
any Note that the parameter “any” is only valid when used
with the netwarerawtagged and netwarerawuntagged
protocol options.
sna-path-control Protocol Number 04 (enter the parameter name or its
number).
proway-lan Protocol Number 0E (enter the parameter name or its
number).
eia-rs Protocol Number 4E (enter the parameter name or its number).
proway Protocol Number 8E (enter the parameter name or its number).
ipx-802dot2 Protocol Number E0 (enter the parameter name or its
number).
netbeui Protocol Number F0 (enter the parameter name or its
number).
iso-clns-is Protocol Number FE (enter the parameter name or its
number).