Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1523)

EPSR Introduction and Configuration
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 57.41
Step 4: Add physical port1.0.1 to VLAN 50
Step 5: Add physical port1.0.3 to VLAN 50
Select the next transit node that connects to the common segment, and repeat the above
steps:
On Ring 1 EPSR Instance Blue - Add VLAN 50 to the Master
Node
Carry out this process using the same basic procedure shown in Steps 1 to 5
On Ring 1 EPSR Instance Blue - Add VLAN 50 to the Transit
Nodes
Carry out this process using the same basic procedure shown in Steps 1 to 5
On Ring 2 EPSR Instance Green - Add VLAN 50 to the Master
Node
Carry out this process using the same basic procedure shown in Steps 1 to 5
On Ring 2 EPSR Instance Green - Add VLAN 50 to the
remaining Transit Node
Carry out this process using the same basic procedure shown in Steps 1 to 5
awplus(config)#
interface port1.0.1 Specify the interface (port1.0.1) that you are
configuring and enter the Interface Configuration
mode.
awplus(config-if)#
switchport trunk allowed vlan add 50 Enable VLAN 50 on this port.
awplus(config-if)#
exit Exit the Interface Configuration mode and enter the
Global Configuration mode.
awplus(config)#
interface port1.0.3 Specify the interface (port1.0.3) that you are
configuring and enter the Interface Configuration
mode.
awplus(config-if)#
switchport trunk allowed vlan add 50 Enable VLAN 50 on this port.
awplus(config-if)#
exit Exit the Interface Configuration mode and enter the
Global Configuration mode.