Active (ping-polling), Active, No active – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 2061

Ping-Polling Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
79.3
active (ping-polling)
This command enables a ping-poll instance. The polling instance sends ICMP echo
requests to the device with the IP address specified by the
command.
By default, polling instances are disabled. When a polling instance is enabled, it assumes
that the device it is polling is unreachable.
The no variant of this command disables a ping-poll instance. The polling instance no
longer sends ICMP echo requests to the polled device. This also resets all counters for this
polling instance.
Syntax
active
no active
Mode
Ping-Polling Configuration
Examples
To activate the ping-poll instance 43, use the commands:
To disable the ping-poll instance 43 and reset its counters, use the commands:
Related Commands
debug ping-poll
ip (ping-polling)
ping-poll
show ping-poll
awplus#
configure terminal
awplus(config)#
ping-poll 43
awplus(config-ping-poll)#
active
awplus#
configure terminal
awplus(config)#
ping-poll 43
awplus(config-ping-poll)#
no active