Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 894)

IPv4 Software Access Control List (ACL) Commands
Software Reference for x310 Series Switches
35.8 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
<destination> The destination address of the packets. You can specify a single
host, a subnet, or all destinations. The following are the valid
formats for specifying the destination:
any Matches any destination IP address.
host Matches a single destination host with
the IP address given by in
dotted decimal notation.
<ip-addr>/
<prefix> An IPv4 address, followed by a forward
slash, then the prefix length. This
matches any destination IP address
within the specified subnet.
<ip-addr>
<reverse-mask> Alternatively, you can enter a reverse
mask in dotted decimal format. For
example, entering 192.168.1.1
0.0.0.255
is the same as entering
192.168.1.1/24 .
<sourceport> The source port number, specified as an integer between 0 and
65535.
<destport> The destination port number, specified as an integer between 0
and 65535.
eq Matches port numbers equal to the port number specified
immediately after this parameter.
lt Matches port numbers less than the port number specified
immediately after this parameter.
gt Matches port numbers greater than the port number specified
immediately after this parameter.
ne Matches port numbers not equal to the port number specified
immediately after this parameter.
log Log the results.
Table 35-3: Parameters in the access-list extended (named) command - tcp|
Parameter(cont.) Description(cont.)