Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 602)

Power over Ethernet Commands
Software Reference for x310 Series Switches
23.4 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
debug power-inline
This command enables debugging display for messages that are specific to Power over
Ethernet (PoE).
Use the no variant of this command to disable the specified PoE debugging messages.
Syntax debug power-inline [all|event|info|power]
no debug power-inline [all|event|info|power]
Default No debug messages are enabled by default.
Mode Privileged Exec
Usage Use the terminal monitor command to display PoE debug messages on the console.
Use the show debugging power-inline command to show the PoE debug configuration.
Examples To enable PoE debugging and start the display of PoE event and info debug messages
on the console, use the following commands:
To enable PoE debugging and start the display of all PoE debugging messages on the
console, use the following commands:
To disable PoE debugging and stop the display of PoE event and info debug messages
on the console, use the following command:
Parameter Description
all Displays all (event, info, nsm, power) debug messages.
event Displays event debug information, showing any error conditions
that may occur during PoE operation.
info Displays informational level debug information, showing high-level
essential debugging, such as information about message types.
power Displays power management debug information.
awplus# terminal monitor
awplus# debug power-inline event info
awplus# terminal monitor
awplus# debug power-inline all
awplus# no debug power-inline event info