User-defined working-set groups – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1580

AMF Introduction and Configuration
Software Reference for x310 Series Switches
59.36
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
To select a working-set group use the
command with the group
parameter, followed by the group name. You can specify a single group, a comma
separated list of groups, or even a comma separated list of individual nodes, followed by a
comma separated list of groups:
User-defined working-set groups
In addition to the automatic working-set groups, it is also possible to create user-defined
groups for arbitrary sets of nodes that the user may wish to group together. For example,
all AMF master nodes.
To create and use a user-defined working-set group:
1.
Create a working-set containing the desired nodes.
2.
In global configuration mode use the command:
You can see all user-defined working-set groups that exist on the AMF network with the
command
atmf1[3]#
atmf working-set group x511Node2
Working set join
% Warning – working set is now empty
atmf1[0]#
Master#
atmf working-set Master1,Master2
Working set join
% Warning – working set is now empty
atmf1[2]#
conf t
atmf1[2]#
atmf group Masters
x908_VCS_1#show atmf group members automatic
Retrieving Automatic groups from:
x510_1 Master x908_VCS_2 x908_VCS_1
ATMF Group membership
Automatic Total
Groups Members Members
poe 1 Master
x510 1 x510_1
SBx8100 1 Master
x900 2 x908_VCS_2 x908_VCS_1