Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1659)

AMF Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 60.71
show running-config atmf
This command displays the running system information that is specific to AMF.
Syntax show running-config atmf
Mode User Exec and Global Configuration
Example To display the current configuration of AMF, use the following commands:
Related Commands show running-config
no debug all
switchport atmf-crosslink
This command configures the selected port or aggregated link to be an AMF crosslink.
Running this command will automatically place the port or aggregator into trunk mode
(i.e. switchport mode trunk).
The connection between two AMF masters must utilize a crosslink. Crosslinks are used to
carry the AMF control information between master nodes. Multiple crosslinks can be
configured between two master nodes, but only one crosslink can be active at any
particular time. All other crosslinks between masters will be placed in the blocking state, in
order to prevent broadcast storms.
The “no” variant of this command removes any crosslink that may exist for the selected
port or aggregated link.
Syntax switchport atmf-crosslink
no switchport atmf-crosslink
Mode Interface Configuration
Usage Crosslinks can be used anywhere within an AMF network. They have the effect of
separating the AMF network into separate domains.
node_1# show running-config atmf
Note You can manage your show output, or make it a more selective, by using a command
modifier. For information on using show-command modifiers, see:
“Controlling “show”
Command Output” on page 1.37 .
Parameter Description
switchport The Layer 2 Interface.
atmf-crosslink Sets the switchport to be an AMF crosslink.