Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 332)

Interface Commands
Software Reference for x310 Series Switches
12.12 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show interface status
Use this command to display the status of the specified interface or interfaces. Note that
when no interface or interfaces are specified then the status of all interfaces on the switch
are shown.
Syntax show interface [<port-list>] status
Examples To display the status of ports 1.0.1 to 1.0.5, use the commands:
To display the status of all ports, use the commands:
Parameter Description
<port-list> The ports to display information about. The port list can be:
■
a switch port (e.g. port1.0.6) a static channel group (e.g. sa2)
or a dynamic (LACP) channel group (e.g. po2)
■
a continuous range of ports separated by a hyphen,
e.g. port1.0.1-1.0.6, or sa1-2, or po1-2
■ a comma-separated list of ports and port ranges,
e.g. port1.0.1,port1.0.4-1.0.6. Do not mix switch ports,
static channel groups, and dynamic (LACP) channel groups in the
same list
awplus# show interface port1.0.1-1.0.5 status
Figure 12-5: Example output from the show interface status command
awplus#show interface port1.0.1 -1.0.5 status
Port Name Status Vlan Duplex Speed Type
port1.0.1 notconnect 1 auto auto 1000BASE-T
port1.0.2 notconnect 1 auto auto 1000BASE-T
port1.0.3 notconnect 1 auto auto 1000BASE-T
port1.0.4 notconnect 1 auto auto 1000BASE-T
port1.0.5 notconnect 1 auto auto 1000BASE-T
awplus# show interface status
Figure 12-6: Example output from the show interface status command
awplus#sho int status
Port Name Status Vlan Duplex Speed Type
port1.0.1 Trunk_Net connected trunk a-full a-1000 1000BaseTX
port1.0.2 Access_Net1 connected 5 full 100 1000BaseTX
port1.0.3 Access_Net1 disabled 5 auto auto 1000BaseTX
port1.0.4 Access_Net2 connected 6 a-half a-100 1000BaseTX
port1.0.5 Private_Prom connected 10 a-full a-100 1000BaseTX
port1.0.6 Private_Net1 connected 10,11 a-full a-100 1000BaseTX
port1.0.7 Private_Net2 connected 10,12 a-full a-100 1000BaseTX
port1.0.8 notconnect 1 auto auto 1000BaseTX
.
.
port1.0.23 disabled 1 auto auto not present
port1.0.24 notconnect 1 auto auto unknown
sa1 notconnect trunk auto auto