Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 957

IPv6 Software Access Control List (ACL) Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

Operating System - Version 5.4.4C

37.5

permit

The IPv6 software extended access-list permits packets
that match the type, source, and destination filtering
specified with this command.

any

For ICMP|IP
The IPv6 software extended access-list matches any
type of packet.

For ICMP|IP
The IPv6 software extended access-list matches only IP
packets.

icmp

For ICMP|IP
The IPv6 software extended access-list matches only
ICMP packets.

tcp

For TCP/UDP
The IPv6 software extended access-list matches only
TCP packets.

udp

For TCP/UDP
The IPv6 software extended access-list matches only
UDP packets.

<ipv6-source-
address/prefix-
length>

Specifies a source address and prefix length.
The IPv6 address prefix uses the format X:X::/prefix-
length. The prefix-length is usually set between 0 and
64.

<ipv6-destination-
address/prefix-
length>

Specifies a destination address and prefix length.
The IPv6 address uses the format X:X::X:X/Prefix-
Length. The prefix-length is usually set between 0 and
64.

any

Matches any IPv6 address.

<sourceport>

For TCP/UDP
The source port number, specified as an integer
between 0 and 65535.

<destport>

For TCP/UDP
The destination port number, specified as an integer
between 0 and 65535.

icmp-type

For ICMP|IP
Matches only a specified type of ICMP messages. This is
valid only when the filtering is set to match ICMP pack-
ets.

For TCP/UDP
Matches port numbers equal to the port number speci-
fied immediately after this parameter.

For TCP/UDP
Matches port numbers less than the port number spec-
ified immediately after this parameter.

Parameter(cont.)

Description(cont.)