Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 614
Power over Ethernet Commands
Software Reference for x310 Series Switches
23.16
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
Table 23-1: Parameters in the show power-inline command output
Parameter Description
Nominal Power
The nominal power available on the switch in watts (W).
Power Allocated
The current power allocated in watts (W) that is available to
be drawn by any connected Powered Devices (PDs). This is
updated every 5 seconds.
Actual Power
Consumption
The current power consumption in watts (W) drawn by all
connected Powered Devices (PDs). This is updated every 5
seconds.
Operational
Status
The operational status of the PSU hardware on the PSE
when this command was issued:
■
On if the PSU as installed inside the PSE is switched on.
■
Off when the PSU in the PSE is switched off (an RPS may
be connected to the PSE to power PoE instead of the
PSU).
■
Fault when there is an issue with the PSE PSU hardware.
Power Usage
Threshold (%)
The configured SNMP trap / log threshold for the PSE, as
configured from a
command.
Interface
The PoE port(s) in the format portx.y.z, where x is the
device number, y is the module number within the device,
and z is the PoE port number within the module.
Admin
The administrative state of PoE on a PoE port, either
Enabled or Disabled.
Pri
The current PoE priorities for PoE ports on the PSE, as
configured from a
■
Low displays when the low parameter is issued.
The lowest priority for a PoE enabled port (default).
■
High displays when the high parameter is issued.
The second highest priority for a PoE enabled port.
■
Crit displays when the critical parameter is issued.
The highest priority for a PoE enabled port.
Oper
The current PSE PoE port state when this command was
issued:
■
Powered displays when there is a PD connected and
power is being supplied from the PSE.
■
Disabled displays when supplying power would make the
PSE go over the power budget.
■
Off displays when PoE has been disabled for the PoE port.
Fault displays when a PSE goes over its power allocation.
Power
The power consumption in milliwatts (mW) for the PoE port
when this command was entered.
Device
The description of the connected PD device if a description
has been added with the
command. No description is shown for PDs not configured
with the
command.