Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 248)

System Configuration and Monitoring Commands
Software Reference for x310 Series Switches
8.48 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show system interrupts
Use this command to display the number of interrupts for each IRQ (Interrupt Request)
used to interrupt input lines on a PIC (Programmable Interrupt Controller) on your switch.
For information on output options, see “Controlling “show” Command Output” on
page 1.37 .
Syntax show system interrupts
Mode User Exec and Privileged Exec
Example To display information about the number of interrupts for each IRQ in your device, use the
command:
Output Figure 8-19: Example output from the show system interrupts command
Related Commands show system environment
awplus# show system interrupts
awplus#show system interrupts
CPU0
5: 10428098 Enabled 0 MIPS linux-kernel-bde
6: 0 Enabled 0 MIPS bcma-usb-ohci:usb1, bcma-usb-ehci:
usb2
7: 300725368 Enabled 0 MIPS timer
18: 598364339 Enabled 0 MIPS-CC bcma_i2c
22: 4909 Enabled 0 MIPS-CC serial
31: 1 Enabled 0 MIPS-GPIO GPIO-Ethernet PHY
35: 2 Enabled 0 MIPS-GPIO GPIO-ECO Button
40: 4 Enabled 0 MIPS-GPIO PSU Interrupt
42: 0 Enabled 0 MIPS-GPIO PSU2 power good
43: 0 Enabled 0 MIPS-GPIO PSU1 power good
ERR: 0
awplus#