Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 873
IPv4 Hardware Access Control List (ACL) Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
34.27
The source address of the packets. You can specify a
single host, a subnet, or all sources. The following are the
valid formats for specifying the source:
any
Matches any source IP address.
host
Matches a single source host with
the IP address given by
in dotted decimal
notation.
<ip-addr>/
<prefix>
An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any source
IP address within the specified
subnet.
<ip-addr>
<reverse-mask>
Alternatively, you can enter a
reverse mask in dotted decimal
format. For example, entering
192.168.1.1 0.0.0.255
is
the same as entering
192.168.1.1/24
.
<destination>
The destination address of the packets. You can specify a
single host, a subnet, or all destinations. The following are
the valid formats for specifying the destination:
any
Matches any destination IP
address.
host
Matches a single destination host
with the IP address given by
in dotted decimal
notation.
<ip-addr>/
<prefix>
An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any
destination IP address within the
specified subnet.
<ip-addr>
<reverse-mask>
Alternatively, you can enter a
reverse mask in dotted decimal
format. For example, entering
192.168.1.1 0.0.0.255
is
the same as entering
192.168.1.1/24
.
mac
Signifies a MAC and based hardware access-list.
<mac-source-
address>
The source host’s MAC address, entered in
HHHH.HHHH.HHHH format.
<mac-source-mask>
The source host’s MAC wildcard mask entered in
HHHH.HHHH.HHHH format.
where Hex FF = Ignore, and Hex 00 = Match.
Parameter(cont.)
Description(cont.)