Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2022)

Trigger Commands
Software Reference for x310 Series Switches
77.2 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Command List
This chapter provides an alphabetical reference for commands used to configure Triggers.
For more information, see
Chapter 75, Triggers Introduction and Chapter 76, Triggers
Configuration .
For information about modifying or redirecting the output from show commands to a file,
see
“Controlling “show” Command Output” on page 1.37 .
active (trigger)
This command enables a trigger. This allows the trigger to activate when its trigger
conditions are met.
The no variant of this command disables a trigger. While in this state the trigger cannot
activate when its trigger conditions are met.
Syntax active
no active
Mode Trigger Configuration
Usage Configure a trigger first before you use this command to activate it. See the Configuring a
Trigger section in Chapter 75, Triggers Introduction for trigger configuration steps.
Examples To enable trigger 172, so that it can activate when its trigger conditions are met, use the
commands:
To disable trigger 182, preventing it from activating when its trigger conditions are met,
use the commands:
Related Commands show trigger
trigger
awplus# configure terminal
awplus(config)# trigger 172
awplus(config-trigger)# active
awplus# configure terminal
awplus(config)# trigger 182
awplus(config-trigger)# no active