Show epsr – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1536

EPSR Commands
Software Reference for x310 Series Switches
58.10
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
show epsr
This command displays information about all EPSR instances.
Syntax
show epsr
Mode
User Exec and Privileged Exec
Example
To show the current settings of all EPSR instances, use the command:
Output
The following examples show the output display for a non superloop topology network.
The following example show the output display for superloop topology network.
awplus#
show epsr
Figure 58-1: Example output from the show epsr command run on a transit node
EPSR Information
---------------------------------------------------------------
Name ........................ test2
Mode .......................... Transit
Status ........................ Enabled
State ......................... Links-Up
Control Vlan .................. 2
Data VLAN(s) .................. 10
Interface Mode ................ Ports Only
First Port .................... port1.0.1
First Port Status ............. Down
First Port Direction .......... Unknown
Second Port ................... port1.0.2
Second Port Status ............ Down
Second Port Direction ......... Unknown
Trap .......................... Enabled
Master Node ................... Unknown
Enhanced Recovery ............. Disabled
---------------------------------------------------------------