Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 159)

File Management Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 7.13
copy debug
This command copies a specified debug file to a destination file. Specify whether the
destination is Flash or Card when saving the software to the local filesystem.
This command copies a specified debug file to a destination file. Specify whether the
destination is Flash or USB when saving the software to the local filesystem.
Syntax copy debug {<destination-url>|card|debug|flash|nvs|scp|tftp|usb}
{<source-url>|card|debug|flash|nvs|scp|tftp|usb}
Mode Privileged Exec
Example To copy debug output to an SD (or SDHC) card with a filename my-debug, use the
following command:
To copy debug output to a USB storage device with a filename my-debug, use the
following command:
Output Figure 7-2: CLI prompt after entering the copy debug command
Related Commands delete debug
move debug
Parameter Description
The URL where you would like the debug output saved. See
“URL Syntax and Keyword Usage” on page 7.3 for valid
URL syntax.
The URL where the debug output originates. See “URL
Syntax and Keyword Usage” on page 7.3 for valid URL
syntax.
awplus# copy debug card:mydebug
awplus# copy debug usb:mydebug
Enter source file name []: