Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1733)

Dynamic Host Configuration Protocol (DHCP) Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 64.35
Related Commands show counter dhcp-server
service dhcp-server
show ip dhcp binding
show ip dhcp pool
DHCPNAK out The number of Negative Acknowledgement
messages sent by the DHCP server. The server sends
these after receiving a request that it cannot fulfil
because either there are no available IP addresses in
the related address pool, or the request has come
from a client that doesn’t fit the network setting for
an address pool.
BOOTREQUEST in The number of bootp messages received by the
DHCP server from bootp clients.
BOOTREPLY out The number of bootp messages sent by the DHCP
server to bootp clients.
DHCPLEASEQUERY in
The number of Lease Query messages received by
the DHCP server from DHCP Relay Agents.
DHCPLEASEUNKNOWN out
The number of Lease Unknown messages sent by
the DHCP server to DHCP Relay Agents.
DHCPLEASEACTIVE out
The number of Lease Active messages sent by the
DHCP server to DHCP Relay Agents.
DHCPLEASEUNASSIGNED out
The number of Lease Unassigned messages sent by
the DHCP server to DHCP Relay Agents.
Figure 64-10: Parameters in the output of the show counter dhcp server statistics
command(cont.)