Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 28)

Getting Started
Software Reference for x310 Series Switches
1.4 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
This results in the following output:
Examples To use the ? help to work out the syntax for the clock timezone command, enter the
following sequence of commands:
The above example demonstrates that the ? help only indicates what you can type next.
For commands that have a series of parameters, like clock timezone, the ? help does not
make the number of parameters obvious.
Figure 1-2: Example output from the show i? command
interface Select an interface to configure
ip Internet Protoc6ol (IP)
ipv6 Internet Protocol version 6 (IPv6)
awplus(config)# clock ?
summer-time Manage summer-time
timezone Set clock timezone
awplus(config)# clock timezone ?
TIMEZONE Timezone name, up to 5 characters
awplus(config)# clock timezone NZST ?
minus negative offset
plus positive offset
awplus(config)# clock timezone NZST plus ?
<0-12> Time zone offset to UTC
awplus(config)# clock timezone NZST plus 12