Location coord-location identifier, Location coord-location, Identifier
Page 1956

LLDP Commands

Software Reference for x310 Series Switches

71.30

AlliedWare Plus

Operating System - Version 5.4.4C

C613-50046-01 REV A

location coord-location identifier

Use this command to enter Coordinate Location Configuration mode for this coordinate
location.

Use the no variant of this command to delete a coordinate location. This also removes the
location from any ports it has been assigned to.

Syntax

location coord-location identifier <coord-loc-id>

no location coord-location identifier <coord-loc-id>

Default

By default there are no coordinate locations.

Mode

Global Configuration

Usage

Up to 400 locations can be configured on the switch for each type of location information,
up to a total of 1200 locations.

To configure this coordinate location, use the

command. To associate this coordinate location with particular ports, so that it can be
advertised in TLVs from those ports, use the

command.

Examples

To enter Coordinate Location Configuration mode to configure the coordinate location
with ID 1, use the commands:

To delete coordinate location 1, use the commands:

Related Commands

Parameter Description

<coord-loc-id>

A unique coordinate location identifier, in the range 1 to
4095.

awplus#

configure terminal

awplus(config)#

location coord-location identifier 1

awplus(config-coord)#

awplus#

configure terminal

awplus(config)#

no location coord-location identifier 1

Page 1956