Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 920)

IPv4 Software Access Control List (ACL) Commands
Software Reference for x310 Series Switches
35.34 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
(access-list standard numbered filter)
This ACL filter adds a source IP address filter entry to a current standard numbered access-
list. If a sequence number is specified, the new filter entry is inserted at the specified
location. Otherwise, the new filter entry is added at the end of the access-list.
The no variant of this command removes a source IP address filter entry from the current
standard numbered access-list. You can specify the source IP address filter entry for
removal by entering either its sequence number (e.g. no 10), or by entering its source IP
address filter profile without specifying its sequence number.
Note that the sequence number can be found by running the show access-list (IPv4
Software ACLs) command.
Syntax [<sequence-number>] {deny|permit} {<source>|host <host-address>|any}
no {deny|permit} {<source>|host <host-address>|any}
no <sequence-number>
Mode IPv4 Standard ACL Configuration
Default Any traffic controlled by a software ACL that does not explicitly match a filter is denied.
Parameter Description
<sequence-number> <1-65535>
The sequence number for the filter entry of the
selected access control list.
deny Access-list rejects packets of the type specified.
permit Access-list allows packets of the type specified
<source> The source address of the packets. You can specify
either a subnet or all sources. The following are the
valid formats for specifying the source:
<ip-addr>
<reverse-mask> Enter a reverse mask for the
source address in dotted
decimal format. For example,
entering 192.168.1.1
0.0.0.255
is the same as
entering 192.168.1.1/24.
An IPv4 address in a.b.c.d
format.
host A single source host.
<host-address> Single source host address.
any Matches any source IP address.