Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 798)

MLD and MLD Snooping Introduction and Commands
Software Reference for x310 Series Switches
32.14 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
ipv6 mld last-member-query-count
Use this command to set the last-member query-count value.
Use the no variant of this command to return to the default on an interface.
Syntax ipv6 mld last-member-query-count
no ipv6 mld last-member-query-count
Default The default last-member query-count value is 2.
Mode Interface Configuration for a specified VLAN interface or a range of VLAN interfaces.
Example
Parameter Description
Count value. Valid values are from 2 to 7.
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# interface vlan2
awplus(config-if)# ipv6 enable
awplus(config-if)# ipv6 mld last-member-query-count 3