Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2057)

Ping Polling Introduction and Configuration
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 78.7
The upcount is the number of consecutive pings that must be answered for the polling
instance to consider the device reachable again. To change this from the default of 30, use
the command:
Checking the
configuration
To check the settings and status of the polling instance, use the command:
Troubleshooting Ping Polling
To disable a polling instance, use the command:
The polling instance no longer sends ICMP echo requests to the polled device and the
counters for this polling instance are reset.
To clear the counters and change the status of a device to unreachable, enter the
Privileged Exec mode and use the command:
The polling instance changes to the polling frequency specified with the critical-interval
command. The device status changes to reachable once the device responses have
reached the
up-count .
To start debugging for ping polling, use the command:
awplus(config-ping-poll)# up-count <1-100>
awplus(config-ping-poll)# show ping-poll [<1-100>|state {up|
down}] [brief]
awplus(config-ping-poll)# no active
awplus# clear ping-poll {<1-100>|all}
awplus# debug ping-poll <1-100>