Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2147)

Stacking Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 83.7
Topology Message counters
Tx Total ......... 4
Tx Hellos ......... 4
Tx Topo DB ......... 0
Tx Topo update ......... 0
Tx Link event ......... 0
Tx Reinitialise ......... 0
Tx Port 1 ......... 4
Tx Port 2 ......... 0
Tx 1-hop transport ......... 4
Tx Layer-2 transport ......... 0
Rx Total ......... 1
Rx Hellos ......... 1
Rx Topo DB ......... 0
Rx Topo update ......... 0
Rx Link event ......... 0
Rx Reinitialise ......... 0
Rx Port 1 ......... 1
Rx Port 2 ......... 0
Rx 1-hop transport ......... 1
Rx Layer-2 transport ......... 0
Topology Error counters
Version unsupported ......... 0
Product unsupported ......... 0
XEM unsupported ......... 0
Too many units ......... 0
Invalid messages ......... 0
Resiliency Link counters
Health status good ......... 1
Health status bad ......... 0
Tx ......... 0
Tx Error ......... 0
Rx ...... 3600
Rx Error ......... 0
Stack member 2:
-- Output repeated for other stack members - details not shown--
Table 83-1: Parameters in the output of the show counter stack command
Parameters Description
Topology Event Counters
Units joined Number of times that the stack acquires a member.
Units left Number of times that the stack loses a member.
Links up Number of times that a stack link is up in the stack.
Links down Number of times that a stack link is down in the stack.
ID conflict Number of times that stack-ID conflicts.
Master conflict Number of times that stack master conflict occurs.
Master failover Number of times that stack master fails.
Master elected Number of times that stack master is elected.
Master
discovered Number of times that stack master is discovered.
SW autoupgrades Number of times that the software in the stack members are
auto upgraded.
Stack port counters
Link up Number of times that this unit's physical stack link has come
up.
Figure 83-1: Example output from the show counter stack command