Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1637)

AMF Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 60.49
A typical output screen from this command is shown below:
This confirms that the six nodes (node_1 to node6) are now members of the working-set
and that these nodes reside within the AMF-Test-Network.
Note that to run this command, you must have previously entered the “atmf working-
set” on page 60.31 . This can be seen from the network level prompt, which in this case
ATM_Network[6}#.
ATMF group information
master, poe, x8100
=========================================
node-1, node-2, node33, node-4, node-5, node-6:
==============================================
ATMF group information
sysadmin, x8100
ATMF-Test-NETWORK[6]#
Figure 60-7: Sample output from the show atmf group command for a working set.
ATMF_NETWORK[6]#show atmf group
===========================
node3, node4, node5, node6:
===========================
ATMF group information
edge_switches, x510
Figure 60-8: Parameter definitions from the show atmf group command
Parameter Definition
ATMF group information Displays a list of nodes and the groups that they belong to,
for example:
■ master - Shows a common group name for Nodes
configured as AMF masters.
■ Hardware Arch - Shows a group for all Nodes sharing a
common Hardware architecture: e.g: x8100, x900, x610
etc.
■ User-defined - Arbitrary groups created by the user for
AMF nodes.