Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1504)

EPSR Introduction and Configuration
Software Reference for x310 Series Switches
57.22 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
On Ring 1- Configure the Master Node R-1
Step 1: Create the control and data VLANs (Configure on the Master Node R-1)
Step 2: Add the control VLAN (ctrl-blue) to the Ring Ports
Note x310 Series switches within an EPSRing can only operate as Transit Nodes. To
form an EPSR ring using x310 Series switches, you will need to use an alternative
Allied Telesis switch, such as an x610 Series switch or an x510 Series switch with
a Premium License, as the master node.
In the configuration examples shown in this chapter, master node configuration
is included for completeness. However, the commands shown will need to be
applied to the switch selected to be the master node.
awplus#
configure terminal Enter the Global Configuration mode.
awplus(config)#
vlan database Enter the VLAN Configuration mode.
awplus(config-vlan)#
vlan 5 name ctrl-blue state enable Enable VLAN 5 called ctrl-blue on the Master Node R-1.
Specifying the enable state allows forwarding of frames
on the VLAN-aware node.
awplus(config-vlan)#
vlan 40 name data-a state enable Enable VLAN 40 called data-a on the Master Node R-1.
Specifying the enable state allows forwarding of frames
on the VLAN-aware node.
awplus(config-vlan)#
exit Exit the VLAN Configuration mode and enter the Global
Configuration mode.
awplus(config)#
interface port1.0.1,port1.0.2 Specify the two ring ports (port1.0.1 and
port1.0.2
) that you are configuring and enter the
Interface Configuration mode.
awplus(config-if)#
switchport mode trunk Set the switching characteristics of these ports to
Trunk mode.
awplus(config-if)#
switchport trunk allowed vlan add 5 Enable VLAN 5 on these ports.
awplus(config-if)#
switchport trunk native vlan none Remove the native VLAN from these ring ports.