Stateful_client diagnostic output, Dhcpv6_relay configuration – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1751

DHCP for IPv6 (DHCPv6) Introduction and Configuration
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
65.15
Stateful_Client diagnostic output
See the Stateful Client device diagnostic output after entering the command to clear
bindings:
Once the client has an address delegated, see the binding and associated counters below:
DHCPv6_Relay Configuration
See the below configuration for a device with the hostname DHCPv6_Relay:
Stateful_Client#clear ipv6 dhcp client vlan1
Stateful_Client#show ipv6 interface
Interface IPv6-Address Status Protocol
lo unassigned admin up running
vlan1 fe80::215:77ff:fec9:73a3/64 admin up running
Stateful_Client#show ipv6 interface
Interface IPv6-Address Status Protocol
lo unassigned admin up running
vlan1 2001:db8:20:0:e2e3:7b54:6d72:28b4/64 admin up running
fe80::215:77ff:fec9:73a3/64
Stateful_Client#show count ipv6 dhcp-client
DHCPv6 client counters
SOLICIT out ....... 3
ADVERTISE in ....... 1
REQUEST out ....... 1
CONFIRM out ....... 0
RENEW out ....... 0
REBIND out ....... 0
REPLY in ....... 1
RELEASE out ....... 0
DECLINE out ....... 0
INFORMATION-REQUEST out ....... 0
hostname DHCPv6_Relay
!
vlan database
vlan 2 state enable
!
interface port1.0.2
switchport
switchport mode access
switchport access vlan 2
!
interface vlan1
description to_DHCPv6_Server
ipv6 address 2001:db8:10::2/64
ipv6 enable
!
interface vlan2
description to_Stateful_Client
ipv6 address 2001:db8:20::1/64
ipv6 enable
no ipv6 nd suppress-ra
ipv6 nd managed-config-flag
ipv6 nd other-config-flag
ip dhcp-relay server-address 2001:db8:10::1 vlan1
!
ipv6 forwarding