Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 303)

Logging Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 10.31
log permanent (filter)
This command creates a filter to select messages to be sent to the permanent log.
Selection can be based on the priority/ severity of the message, the program that
generated the message, the logging facility used, a sub-string within the message or a
combination of some or all of these.
The no variant of this command removes the corresponding filter, so that the specified
messages are no longer sent to the permanent log.
Syntax log permanent [level ] [program ]
[facility ] [msgtext ]
no log permanent [level ] [program ]
[facility ] [msgtext ]
Parameter Description
level Filter messages to the permanent log by severity level.
<level> The minimum severity of message to send to the log. The level can be
specified as one of the following numbers or level names, where 0 is
the highest severity and 7 is the lowest severity:
0|emergencies: System is unusable
1|alerts Action must be taken immediately
2|critical Critical conditions
3|errors Error conditions
4|warnings Warning conditions
5|notices Normal, but significant, conditions
6|informational Informational messages
7|debugging Debug-level messages
program Filter messages to the permanent log by program. Include messages
from a specified program in the log.
<program-
name> The name of a program to log messages from, either one of the
following predefined program names (not case-sensitive), or another
program name (case -sensitive) that you find in the log output.
rsvp Resource Reservation Protocol (RSVP)
dot1x IEEE 802.1X Port-Based Access Control
lacp Link Aggregation Control Protocol (LACP)
stp Spanning Tree Protocol (STP)
rstp Rapid Spanning Tree Protocol (RSTP)
mstp Multiple Spanning Tree Protocol (MSTP)
imi Integrated Management Interface (IMI)
imish Integrated Management Interface Shell (IMISH)
epsr Ethernet Protection Switched Rings (EPSR)
irdp ICMP Router Discovery Protocol (IRDP)
rmon Remote Monitoring
loopprot Loop Protection
poe Power-inline (Power over Ethernet)
dhcpsn DHCP snooping (DHCPSN)