Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 260)

System Configuration and Monitoring Commands
Software Reference for x310 Series Switches
8.60 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Table 8-9: Parameters in the output from the show system pluggables diagnostics
command:
Related Commands show system environment
show system pluggable
show system pluggable detail
show system serialnumber
This command shows the serial number information for the switch.
For information on output options, see “Controlling “show” Command Output” on
page 1.37 .
Syntax show system serialnumber
Mode User Exec and Privileged Exec
Example To display the serial number information for the switch, use the command:
Output Figure 8-29: Example output from the show system serialnumber command
Parameter Description
Temp:
(Degrees C) Shows the temperature inside the transceiver.
Vcc: (Volts) Shows voltage supplied to the transceiver.
Tx Bias:
(mA) Shows current to the Laser Diode in the transceiver.
Tx Power:
(mW) Shows the amount of light transmitted from the transceiver.
Rx Power:
(mW) Shows the amount of light received in the transceiver.
Rx LOS: Shows when the received optical level falls below a preset
threshold.
awplus# show system serialnumber
awplus#show system serialnumber
45AX5300X